PYNE autostudios

                                                             CARBON FIBER  REPAIR  AND  FABRICATION

                                       before 

CARBON FIBER WING THAT WAS IN THE SUN TO LONG & HAD SOME AIR POCKETS SHOWING UP. 

                                                    after

 

 THE PHOTOS MAKE IT LOOK PURE BLACK , BUT YOU CAN STILL SEE THE CARBON FIBER PRINT.

                                                        BEFORE
      REAR  VALANCE  FOR  A   ASTON MARTIN.
                                     AFTER
 
 
                                         CARBON FIBER LOWER FRONT AIR DIFFUSER  FOR   McLAREN.                                                                                                  SMALL HOLE WAS PUNCH THROUGH WHEN IT HIT CURB

RECENTLY  MADE  GO-KART SEAT 

NEW PART (top), ASSEMBLED  3- PIECE MOLD (bottom),  and  ORIGINAL (damaged) SEAT (on right)

                                                  FINISHED PRODUCT 

BRAND NEW SEAT,   JUST NEEDS TO BE TRIMMED AND MOLD PARTING LINES REMOVED.

 
 
 
 
 
                       A    PROTOTYPE   DRIFT  BOAT  WE  MADE  FOR  LAVRO  BOATS   IN  2013

The black mold in foreground (without grey plug) makes the blue 16' boat  x 50"wide bottom in background.   With the grey plug ( I designed and built ) installed in the black mold, the white 16' boat with a 58" wide bottom can be built.    Spencer and I built the hull in under  4 hours.  Jeff  built  front deck and rear compartment.  I built  the front pedestal and fabricated the side compartments, also located and glassed in all the parts.   Dustin  gelcoated (color) the interior and started clean up the exterior and finish the rest. (no photos of boat completely done)

 
 
 
 
                                                   SOME SIMPLE  AUTO BODY WORK ON HOOD,        MOVE TO AUTO PAGE LATTER.

BEFORE 

 

AFTER 

 

 

 
 
 
 
 
 
                                                           REAR  VISORS  FOR  90-91  HONDA  PRELUDE.                                                                                                           A  PRODUCTION  PART WE   FABRICATE.